Hi Fellow
I have developed a model (using model builder, ArcGIS 10) for spatial analysis of my project. The model was quite big and took me 3 days to develop. Every time I add a new tool/process in the model I save it to avoid loosing any work. I was about to finish the model and save it but it did not save, showed a message "failed to save the model", even did not permit to copy the model. Eventually I close it without saving & compromising that I will only lose very last process. But once I close it I saw a red cross mark on my model. I opened it in the edit mode but there is no work at all. I searched into the forum but could not find any solution to repair this. I had a look through the article to repair the broken model (http://resources.arcgis.com/en/help/...00000018000000). It says how to fix the broken tool but does not mention to fix broken model.
Any solution would be appreciated.
Thanks in advance
Bilal
I have developed a model (using model builder, ArcGIS 10) for spatial analysis of my project. The model was quite big and took me 3 days to develop. Every time I add a new tool/process in the model I save it to avoid loosing any work. I was about to finish the model and save it but it did not save, showed a message "failed to save the model", even did not permit to copy the model. Eventually I close it without saving & compromising that I will only lose very last process. But once I close it I saw a red cross mark on my model. I opened it in the edit mode but there is no work at all. I searched into the forum but could not find any solution to repair this. I had a look through the article to repair the broken model (http://resources.arcgis.com/en/help/...00000018000000). It says how to fix the broken tool but does not mention to fix broken model.
Any solution would be appreciated.
Thanks in advance
Bilal